General Category > Comic Related Discussion

Fawcett's Funny Animals 31 (unedited scan)

(1/3) > >>

tymime:
Managed to grab this a few months ago at a convention. I haven't finished editing my scan yet though, because I've run into a problem...
My copy seems to have been printed on some screwy crooked paper or something, because when I straighten the images so that the spine is vertical, the other edges of the pages are at weird angles. Here are my results so far: https://www.mediafire.com/folder/2pha5dqkoks22/funny_animals_31
Basically, I'm not sure if I should crop it or fill in the spots where... well, there isn't any paper. Any advice?

Yoc:
Hi Tymime,
These look fine to me as-is.  A tiny bit of cropping is all I would do.
I personally straighten to the artwork when pages are not printed properly and crop the boarders just little bit.

-Yoc

Geo (RIP):
I agree with Yoc, by the way I've run into much worst on printing, how about the panel printing on the edge of the paper at an angle. Fox books had this problem, so lots of editing was needed for those, next would be Charlton with very poor printing, which they printed themselves.

Ty your off to a great start with your scanning, hang in there, you'll do fine.

Geo

tymime:
So you guys recommend cropping then? I might try some sort of hybrid of the two- I'm pretty handy with the context-aware fill...

Yoc:
I would only crop as much as needed but the clone tool could easily replace any missing boarder as well.
Good luck!

Navigation

[0] Message Index

[#] Next page